1. The ice maker must remain level and in good condition, otherwise it may result in failure to deice or increased noise.
2. When the ice maker is working, it is necessary to ensure sufficient usage space. From the data, the gap between the back and left and right sides is greater than 30 centimeters, and the gap between the top is greater than 60 centimeters.
3. The power supply of the ice maker should be used separately, with dedicated power supply and grounding wire. It should also be equipped with fuses and leakage protection switches.
4. The water used in the ice maker should meet the drinking water standards. It is recommended to use pure water or water filtration equipment to filter impurities, otherwise it may cause water pipe blockage and affect the performance of the ice maker.
5. When cleaning the ice maker, the power should be turned off, and it is strictly prohibited to use a water pipe directly aimed at the machine body for flushing. Neutral detergent should be used for wiping, and corrosive solvents such as acid and alkaline are strictly prohibited for cleaning. Henan ice maker.
6. The ice maker must unscrew the inlet hose head for two months, clean the inlet valve filter screen, and prevent sand and mud impurities in the water from blocking the inlet, resulting in a decrease in the amount of water entering and not making ice.
7. The ice maker must clean the surface dust of the condenser every two months, as poor condensation and heat dissipation can cause damage to compressor components. When cleaning, use a vacuum cleaner, small brush, etc. to clean the condensed surface oil and dust. Do not use sharp metal tools to clean to avoid damaging the condenser.
8. The water pipes, sink, refrigerator, and protective film of the ice maker should be cleaned every two months.
9. When the ice maker is not in use, the internal moisture of the machine should be emptied. If conditions permit, equipment such as a hair dryer can be used. After the moisture removal of the ice maker equipment is completed, the ice maker should be placed in a place free of corrosive gases and dry, and must not be outdoors.